8 Infiniium Z-Series Oscilloscopes User’s Guide
RealEdge 1R, 3R Channel Inputs 26
Ground 27
Aux Out 27
Cal Out 27
Probe Compensation Terminal 27
USB Host Ports 27
Front or Back Panel Inputs and Outputs 28
Trig Out 28
Aux Trig 28
Back Panel Inputs and Outputs 29
Motherboard I/O 29
10 MHz In, 10 MHz Out 29
100 MHz In, 100 MHz Out 30
Front Panel Controls (Keys and Knobs) Overview 31
User Interface Overview 32
Menu Overview 35
Using the Setup and Display Controls 37
Starting and Stopping Waveform Acquisitions 38
Adjusting the Horizontal Time Scale and Trigger Position 39
Adjusting the horizontal scale 40
Adjusting the horizontal trigger position (delay) 40
Magnifying a part of the waveform using Zoom 40
Setting the scale, position, and timebase reference 41
Adjusting the Vertical Settings 42
Turning a channel on or off 43
Adjusting the channel’s vertical scale and offset 43
Setting Up Triggers 45
Setting the oscilloscope to trigger on an edge 45
Using Markers and Making a Measurement 47
Making a measurement on a waveform 48
Using quick measurements 48
Using markers 49
Moving markers using the user interface 49
Saving and Printing Data 51
Forcing a Default Setup 52
Infiniium hard drive recovery 52
To Next Page
Loading...
Need help?
General
