Features of your vehicle
304
Safe Exit Warning (SEW)
snow or rain, or installing a trailer or
carrier, it can reduce the detecting
performance and temporarily limit or
disable Blind-Spot Safety system. If
this occurs, the 䳒Blind-spot safety
systems disabled. Radar blocked䳓
warning message will appear on the
cluster.
The function will operate normally
when such foreign matters or trailer,
etc. is removed, and then the engine
is restarted.
If the function does not operate
normally after it is removed, have
the vehicle inspected by a profes
-
sional workshop. Kia recommends to
visit an authorised Kia dealer/ser
-
vice partner.
䳜 Even though the warning mes
-
sage does not appear on the clus
-
ter, Blind-Spot Safety system
may not properly operate.
䳜 Blind-Spot Safety system may
not properly operate in an area
(e.g. open terrain) where any sub
-
stance are not detected right
after the engine is turned on, or
when the detecting sensor is
blocked with foreign matters right
after the engine is turned on.
Turn off Safety Exit Warning to
install a trailer, carrier, etc., or
remove the trailer, carrier, etc. to
use Safety Exit Warning.
Limitations of the function
Safety Exit Warning may not oper
-
ate normally, or the function may
operate unexpectedly under the fol
-
lowing circumstances:
䳜 Driving through a narrow road
where trees or grass or over
-
grown
䳜 Driving on a wet road surface,
such as a puddle in the road
䳜 The speed of the other vehicle is
very fast or slow that it passes by
your vehicle in a short time
For more details on the limitations
of the rear corner radar, refer to
"Blind-Spot Collision-Avoidance
Assist (BCA) (if equipped)" on page
6-105.
To Next Page
Loading...
