Driving your vehicle
546
Brake system
visit an authorised Kia dealer/ser
-
vice partner.
䳜 If the parking brake warning light
does not illuminate or blinks even
though the EPB switch was pulled
up, the EPB is not applied. If the
parking brake warning light blinks
when the EPB warning light is on,
press the switch, then pull it up.
Once more press it back to its
original position and pull it back
up. If the EPB warning does not
go off, have the system checked
by a professional workshop. Kia
recommends to visit an
authorised Kia dealer/service
partner.
AUTO HOLD (if equipped)
The Auto Hold is designed to main
-
tain the vehicle in a standstill even
though the brake pedal is not
pressed after the driver brings the
vehicle to a complete stop by press
-
ing the brake pedal.
Applying Auto Hold function
1. Press the brake pedal and start
the vehicle.
2. Press the Auto Hold button. The
white AUTO HOLD indicator will
come on indicating the system is
in standby.
Before the Auto Hold will engage,
the driver's door, trunk/tailgate
and engine bonnet must be
closed.
When coming to a complete stop by
pressing the brake pedal, the AUTO
HOLD indicator changes from white
to green indicating the AUTO HOLD
is engaged. The vehicle will remain
at a standstill even if you release
the brake pedal.
If EPB is applied, Auto Hold will be
released.
If you press the accelerator pedal
with the gear in D (Drive), R
(Reverse) or manual mode, the Auto
To Next Page
Loading...
