Maintenance
1028
Light bulbs
5. Remove the bulb from the socket
by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
6. Insert a new bulb by inserting it
into the socket and rotating it
until it locks into place.
7. Install the socket into the assem
-
bly by aligning the tabs on the
socket with the slots in the
assembly. Push the socket into
the assembly and turn the socket
clockwise.
8. Reinstall the lamp assembly to
the body of the vehicle.
Stop and tail lamp (LED type) bulb
replacement
Rear combination lamp
䳍 4door Type C, D
Rear combination lamp 䳍 5door Type B
If the stop (1) and tail (2) lamp
(LED), does not operate, have your
vehicle checked by a professional
workshop.
Kia recommends to visit an
authorised Kia dealer/service part
-
ner.
The LED lamps cannot be replaced
as a single unit because it is an inte
-
grated unit. The LED lamps has to
be replaced with the unit.
A skilled technician should check or
repair the stop and tail lamp (LED),
for it may damage related parts of
the vehicle.
To Next Page
Loading...
