Features of your vehicle
444
Windows
detect the resistance and will stop
upward movement. The window will
then lower approximately 30 cm
(11.8 in) to allow the object to be
cleared.
If the window detects the resistance
whilst the power window switch is
pulled up continuously, the window
will stop upward movement then
lower approximately 2.5 cm (1 in).
And if the power window switch is
pulled up continuously again within
5 seconds after the window is low
-
ered by the automatic window
reversal feature, the automatic win
-
dow reversal will not operate.
The automatic reverse feature for
the window is only active when the
"auto up" feature is used by fully
pulling up the switch. The automatic
reverse feature will not operate if
the window is raised using the half
-
way position on the power window
switch.
Always check for obstructions
before raising any window to avoid
injuries or vehicle damage. If an
object less than 4 mm (0.16 in) in
diameter is caught between the
window glass and the upper window
channel, the automatic reverse win
-
dow may not detect the resistance
and will not stop and reverse direc
-
tion.
The automatic reverse feature is
not activated whilst resetting power
window system.
Make sure body parts or other
objects are safely out of the way
before closing the windows to avoid
injuries or vehicle damage.
Power window lock button
The driver can disable the power
window switches on the rear pas
-
sengers' doors by pressing the
power window lock button to the
lock position (pressed).
When the power window lock button
is pressed:
䳜 The driver's master control can
operate all passengers' power
windows.
To Next Page
Loading...
