vi P/N 3102351-EN • REV 005 • ISS 28DEC18
• The dialer contains no user serviceable parts. In case of defects, return the dialer for repair.
• You may not connect the dialer to a public coin phone or a party line service provided by
the telephone company.
Industry Canada information
The Industry Canada label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective, operational, and safety
requirements. Industry Canada does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to
the facilities of the local telecommunications company. The equipment must also be installed
using an acceptable method of connection. The customer should be aware that compliance
with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request the user
disconnect the equipment.
Caution: Users should not attempt to make connections themselves, but should contact the
appropriate electrical inspection authority, or electrician, as appropriate.
Users should ensure for their own protection that the electrical ground connections of the
power utility, telephone lines, and internal metallic water pipe system, if present, are connected
together. This precaution may be particularly important in rural areas.
Note: The Load Number (LN) assigned to each terminal device denotes the percentage of the
total load to be connected to a telephone loop that is used by the device, to prevent
overloading. The termination on a loop may consist of any combination of devices subject only
to the requirements that the sum of the Load Numbers of all the devices does not exceed 100.