90 °C
60 °C
40 °C
Page 43 / 96
9.7. Remote power-on unit (optional)
Switching bathing session on/off
Risk of fire!
Before commissioning the controller, always ensure that there are no flammable
objects near the sauna heater or infrared heater in the cabin.
1. Switch on the main switch on the controller.
2. Press the mode G
button. The LED for the selected bathing mode lights up.
3. The selected bathing mode starts automatically three seconds after the last time a
button is pressed.
D Each time the button is pressed, the next bathing mode is selected.
D If a different program is to be started for the selected bathing mode, see page 61.
D If SANARIUM was used for more than ten minutes prior to the end of the program, the
follow-on program will start automatically after the program has finished. The END LED
flashes in the display of the remote power-on unit during the follow-on program. The
LED goes out after the follow-on program has finished.
D For further steps on using the follow-on program, see page 36.
To Next Page
Loading...
