90 °C
60 °C
40 °C
Page 83 / 96
11.2. Other possible errors
RemedyCauseFault
The sauna heater does not
heat up (when controlled
via TOUCHCONTROL or
Central Building Control
CBC).
The additional option (key)
appears in the display for
30 minutes.
D Remove flammable objects from
the sauna heater.
Within 30 minutes of requesting sauna heater
output on the TOUCHCONTROL or CBC,
press the key switch on the sauna cabin for
1 second.
The additional option (key) does
not appear in the display.
Output from sauna cabin heater
not requested by CBC.
The 30-minute waiting time has
elapsed.
Request output from the sauna cabin heater
via CBC.
Changes to temperature settings
have not been applied.
Press the key switch on the sauna cabin within
30 minutes of changing the settings.
Fan cannot be adjusted. The Climate Manager is
connected.
D The air flow rate is regulated by
the Climate Manager.
The InfraPLUS heaters will
not switch on.
The incorrect bathing mode has
been selected.
Select Infrared bathing mode.
D See page 37.
The temperature in the cabin is
greater than 50 °C.
Open the cabin door and allow the
temperature to fall.
The InfraPLUS heater is not being
supplied with power.
Check the fuse in the power supply.
Switch the power supply on.
The controller ends the bathing
mode automatically.
Check the CAN bus communication with the
InfraPLUS heater.
AQUAVIVA does not
start.
The mains switch on the
AQUAVIVA controller is switched
off.
Switch on the mains switch at the AQUAVIVA
controller.
Aquaviva
The fuse in the feed line to the
AQUAVIVA controller has blown.
Replace or reset the fuse.
The CAN line is interrupted. Check the CAN line.
The expander circuit board is
defective or not plugged in.
Check or replace the expander circuit board
in the AQUAVIVA controller.
To Next Page
Loading...
