User manual - DATA RECORDER and cooperating software
Information on periodical lack of measurement
If any measurement channel, for whatever reasons (e.g. sensor fault), will not record
measurement values, then this situation will be presented on the graph as
interruption
in the
measurement (
Fig.
3.10
).
Fig. 3.10. Interruption in the graph (e.g. sensor fault)
If measurements can not be executed for some time (e.g. power supply fault or the device is
switched off) then the program will show this situation on the graph in the form of two vertical
lines (
Fig.
3.11
).
Fig. 3.11. Vertical lines on the graph - interruption of measurements
To Next Page