Korg Sound on Sound - Page 20

20
2. Locatetheloopendpoint(PointB),thenpresstheA/BSETbutton.
PointBismarkedandtheloopLEDindicatorwilllightupsteadily.
IfthecounterisdisplayedinMBQTimemode,theunitwillauto‐
maticallymarkPointBatthetopofthemeasureafterthemeasure
wh
ereyo
uspecifiedtheendpoint.
Tocancelthesetting,presstheA/BSETbuttonagain.TheloopLED
indicatorwillturnoffandPointsAandBareerased.Youcanalsoset
PointsAandBbypressingandholdingdowntheA/BSETbuttonto
accessthe“APO
INT”and
“BPOINT”parameterpagesrespectively
(seepage33).
3. PresstheA/BLOOPbuttontoturnontheA/BLoopfunction.Theloop
LEDindicatorwilllightup.
4. When theplaybackpositionreachesPointB,itautomaticallyreturnsto
PointAtorepeatA/Bplayback.
5. PresstheA/BLOOPbuttonagaintotu
rnthe
A/BLoopfunctionoff.
TheloopLEDindicatorwillturnoff.
IfyouspecifyPointBatatimepositionbeforePointA,thetimevalue
ofPointAandPointBwillbeswapped.
Theintervalbetw eenPointsAandBshouldbetwosecondsor longer.
YoucannotsetPointBwithintwosecondsofPointA.
Repeat recording (A/B loop recording)
Duringloopplayback,youcanrecordbypressingtheRecordbutton.
1. Refertothe “Repeatplayback(A/Bloopplayback)”sectiontostart
loopplayback.
2. PresstheRecordbuttontoenterRecordReadymode.TheRecordLED
indicatorwillflashslowly.
3. PresstheRecordbuttonagaintoenterRecordmode.Atthispoint,
no
thing
isrecordedyet.Recordingwillstartaftertheplaybackposi‐
tionreturnstoPointAfromPointB.
TheRecordLEDindicatorwillcontinueflashingslowlyuntiltheplay‐
backpositionreachesPointB,thenitwilllightupsteadilywhenthe
playbackpositionreturnstoPointA.
4. When there
cordingposition
reachesPointB,theunitentersRecord
ReadymodeandstartsA/Bloopplayback.TheRecordLEDindicator
willflash.
Ifyouwanttorepeatoverdubbing,presstheRecordbuttonagainto
repeatlooprecording.
Iftheduration betweenPointsAandBisshorterthaneight(8)sec‐
onds,theunitpausesplaybackwhenrecordingiscomplete.Andthen,
theunitautomaticallystartsloopplaybackoftherecordedaudio.