Start-up
33
Pos: 17.21 /BA/I nbetriebnahm e/EasyCut/Pro belauf nach Erst montage @ 3 \mod_12052159 27275_78.doc @ 73555
6.5 Trial run after first installation
Caution!
After the first connection to the tractor, the machine must undergo a trial run.
• The machine must be in working position
• Do not switch on the PTO until the machine is resting on the ground
and you are absolutely sure that there are no persons, animals or
objects in the danger zone.
• Start a trial run of the machine from the driver’s seat of the tractor only.
• Lower the machine into working position.
• Carefully switch in the PTO of the tractor.
• Slowly increase the PTO speed to 1000 rpm.
• Check that the machine is running smoothly and without vibrations.
• Reduce the PTO speed to idling and wait for the cutting discs / mower drums to come to
a stansdstill.
• Raise or lower the machine via the tractor hydraulics.
Pos: 18 /BA/----- Seitenumbruch--- --- @ 0\mod _1196175311 226_0.doc @ 4165
To Next Page
Loading...
