Start-up
30
Pos: 17.9 /Übersc hriften/Übersc hriften 2/F-J/G elenkwelle @ 0\mod_119978 1879794_78.d oc @ 34542
6.2 PTO shaft
Pos: 17.10 /BA/Sic herheit/Gelen kwelle/Sich dr ehende Gel enkwelle_2 @ 0\ mod_1199781 692950_78.doc @ 34523
Danger! - Rotating PTO shaft
Effect: Danger to life or serious injuries
• Install or detach the PTO shaft only with the engine switched off and the ignition key
removed.
• Secure the tractor against rolling.
• Make sure that the PTO shaft is coupled properly (the lock of the PTO shaft must have
snapped in).
• Make sure that the protective devices are attached properly.
• Never use a PTO shaft, the protective devices of which have not been attached.
• Replace damaged protective devices immediately
• Attach the safety chain of the PTO shaft so that the guard tube does not rotate
simultaneously with the PTO shaft.
Pos: 17.11 /BA/Sic herheit/Gelen kwelle/Antri ebsdrehzahl 10 00 beachten @ 3\mod_12047 00292070_78.do c @ 71424
Danger!
Observe drive speed
Effect: Danger to life or serious injuries
• This machine is driven at a maximum PTO speed of 1000 rpm.
Pos: 17.12 /Üb erschriften/Üb erschriften 3/K-O/ Längenanp assung @ 1\mod _1201687632 810_78.doc @ 5 3589
6.2.1 Length adjustment
Pos: 17.13 /BA/Ers tinbetriebna hme/EasyCut/ Längenanpass ung Gelenkwell e EC 32CVF @ 3\mod_1204 701667336_7 8.doc @ 7144 3
AFA-0-006
2
1
Fig. 10:
• Hold the two PTO shaft halves (1) and (2) next to each other
• Check the cover of the special section tubes and guard tubes
• Shorten special section tubes and guard tubes until they can move freely in any operating
position
• For detailed information on adjusting the length, please refer to the operating instructions
of the PTO shaft manufacturer
Pos: 17.14 /BA/-- ---Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4165