Operation
36
Pos: 21.1 /Übersc hriften/Übersc hriften 1/A-E/B edienung @ 0 \mod_119978 9505403_78.doc @ 34825
8 Operation
Pos: 21.2 /Übersc hriften/Übersc hriften 2/U-Z/V or dem Mähei nsatz @ 3\mod _12047883844 65_78.doc @ 73168
8.1 Before mowing
Pos: 21.3 /BA/Sich erheit/Gefahr enhinweise/M ähwerke/Uner wartete Beweg ung der Schnei dwerkzeuge bz w. des Mäh werkes. Fortschle udern von Stein en während des @ 3\mod_1 20478875634 0_78.doc @ 7 3207
Danger! - Unexpected movement of the cutting tools or the mowing unit. Stones are
hurled up during operation
Effect: Danger to life, injuries or damage to the machine.
• Do not carry out work on the disc mower until the PTO has been switched off, the engine
has been turned off and the ignition key has been removed! Secure the tractor against
accidental start-up and against rolling!
• Support the lifted cutter bar! Never step under suspended loads!
• Before using the machine, always check the protective devices for damage. Replace
damaged protective devices immediately.
• Safe operation is only guaranteed if the blades have been fitted according to the
instructions!
• Before starting operation, always check the mowing unit for damaged, missing or worn
blades, retaining bolts, leaf springs and cutting discs/blade drum; replace any parts that
are damaged, missing or worn!
• Always replace missing and damaged blades in sets to prevent unbalanced rotation!
• Never install unevenly worn blades on a drum/disc!
• Whenever a blade is changed, also inspect the fasteners and, if required, replace them!
• Move the protective devices into their protective positions.
Pos: 21.4 /BA/Be dienung /Eas yCut/Mähen/Hi nweis Beim M ähen Frontmä hwerke @ 33\mo d_125411793 4018_78.doc @ 318312
Note while mowing
Effect: Proper use of the machine
• Change the front power lift to single-acting (only lifting, no pressing). The lowering of the
mowing unit results from the dead weight of the mowing unit. The mowing unit must not
be additionally loaded over the front power lift.
• During work the hydraulic control lever for the front power lift must be set to “Float
position“.
Pos: 21.5 /BA/Be dienung /Eas yCut/Mähen/A bsperrhahn für di e Fronthydra ulik des Traktors lösen. @ 33\m od_125411 9058096_78.doc @ 318361
• Open the shut-off valve for the front hydraulic of the tractor.
Pos: 21.6 /BA/---- -Seitenumbruch-- ---- @ 0\ mod_1196175311 226_0.doc @ 4165
To Next Page
Loading...
Need help?
General
