Maintenance – lubrication chart
68
Pos: 27.31.1 /Üb erschriften/Üb erschriften 1/U-Z/ Wartung - Sc hmierplan @ 0 \mod_1197 359304198_78.doc @ 18232
11 Maintenance – lubrication chart
Pos: 27.31.2 /Üb erschriften/Üb erschriften 2/P-T /Spezielle Sich erheitshinweis e @ 0\mod_1 19666049576 0_78.doc @ 9 134
11.1 Special Safety Instructions
Pos: 27.31.3 /B A/Sicherheit/Ge fahrenhinweise /Mähwerke/G efahr Wartung allgemein EasyC ut @ 11\mod _12236201983 01_78.doc @ 148349
Danger!
When performing repair, maintenance or cleaning work on the machine, or in
the case of technical intervention, drive elements may start moving (caution,
the cutting discs continue to run).
Effect: Danger to life, injuries or damage to the machine.
• Move the machine to the working position and lower it to the ground
• Switch off the tractor engine and remove the ignition key.
• Secure the tractor against accidental start-up and against rolling.
• Switch off the PTO and disengage it.
• After repair, maintenance, cleaning work or technical modifications are
complete, mount all protective coverings and safety devices again
properly.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In the event of injuries or burns due to oils, cleaning agents or solvents,
contact a doctor immediately.
• All other safety instructions must also be followed to avoid injuries and
accidents.
Pos: 27.31.4 /Üb erschriften/Üb erschriften 2/F-J/ Gelenkwelle @ 0\mod_11 99781879794 _78.doc @ 3454 2
11.2 PTO shaft
Pos: 27.31.5 /B A/Wartung/Eas yCut/Absch mieren Gelen kwelle EasyCut @ 3 \mod_120473 0241508_78. doc @ 72667
Fig. 38:
Lubricate the PTO shafts at the intervals indicated in the drawing with a multi-purpose grease.
Follow the operating instructions of the PTO shaft manufacturer.
Pos: 27.31.6 /B A/-----Seitenu mbruch------ @ 0\mod_119617 5311226_0.doc @ 4165
To Next Page
Loading...
Need help?
General
