Maintenance
53
Pos: 27.25.6 /Üb erschriften/Üb erschriften 3/K- O/Ölkontrolle @ 0\mod_11970 21908190_78. doc @ 16120
10.8.2 Checking the oil level
Pos: 27.25.7 /B A/Sicherheit/Ge fahrenhinweise /Mähwerke/Sc hnell rotierend e Messerteller/M essertro mmel_2 @ 0\mod_ 11970225692 52_78.doc @ 16 165
Danger!
Rapidly rotating cutting discs/blade drums.
Effect: Danger to life or serious injuries.
Lower guards. Nobody should be in the danger zone around the machine.
Pos: 27.25.8 /B A/Sicherheit/Ge fahrenhinweise /Mähwerke/Sc hnell rotierend e Messerteller/M essertro mmeln_1 @ 0\mod _1197017696 736_78.doc @ 1 6001
Danger!
Rapidly rotating cutting discs/blade drums.
Effect: Danger to life or serious injuries.
• Switch off the engine and remove the ignition key.
• The cutting discs/blade drums continue to run!
• Do not leave the driver’s cab until the cutting discs/blade drums have
come to a complete stop.
Pos: 27.25.9 /B A/Wartung/Mäh werke/Ölkontr olle Mähholm Easycut @ 3\ mod_1204723206 930_78.doc @ 72428
Allow the machine to run briefly. Do not leave the driver’s cab until the cutting discs/blade drums
have come to a complete stop.
EC-0-003
Fig. 25:
Check the oil level before every use
• Remove the oil level inspection screw (1) from the cutting disc hub.
• The oil level must be up to the bore hole. If required, top up the oil (SAE 90)
• Screw in the oil level inspection screw (1) again and tighten securely.
Pos: 27.26 /BA/-- ---Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4165
To Next Page
Loading...
Need help?
General
