104 / 151 Issued: 16.06.2010 Version: MA KL 1500-3 T S 141215 V1 en
KL 1500-3; KL 1500-3 T; KL 1500-3 S
13.2 Storage
Description If the linear unit is to be put into long-term storage, the following points must
be observed:
The place of storage must be as dry and dust-free as possible.
Avoid temperature fluctuations.
Avoid wind and drafts.
Avoid condensation.
Use appropriate coverings that cannot detach themselves and which can
withstand the expected environmental conditions.
Do not leave any loose parts on the linear unit, especially ones that might
knock against other parts.
Do not leave the linear unit exposed to direct sunlight while in storage.
Observe and comply with the permissible temperature ranges for storage.
See Section (>>> 4 "Technical data" page 17).
Select a storage location in which the covers cannot be damaged.
Procedure 1. Remove tools and equipment.
Fig. 13-1: Removing the linear unit
1 Carriage 4 Connector XP7
2 Lifting tackle 5 Beam
3 Connector XM7 6 Fork lift truck
To Next Page
Loading...