41 / 151Issued: 16.06.2010 Version: MA KL 1500-3 T S 141215 V1 en
6. Planning
6 Planning
6.1 Mounting base
Description The linear unit is fastened to the floor with M16 (standard) or M20 (alternative)
chemical anchors (resin-bonded anchors). M16 chemical anchors are in-
stalled with a Dynamic Set in the floor.
The mounting base (>>> Fig. 6-1) consists of:
Plate
Chemical anchors (resin-bonded anchors) with Dynamic Set
(optionally without Dynamic Set)
Fasteners
This mounting variant requires a level and smooth surface on a concrete foun-
dation with adequate load bearing capacity. The concrete foundation must be
able to accommodate the forces occurring during operation. The minimum di-
mensions must be observed.
Grade of concrete
for foundations
When producing foundations from concrete, observe the load-bearing capac-
ity of the ground and the country-specific construction regulations. The con-
crete must have no cracks and fulfill the following norms for quality:
B25 according to DIN 1045:1988
C20/25 according to DIN EN 206-1:2001/DIN 1045-2:2001
Fig. 6-1: Mounting base
1 Concrete foundation, free from
cracks
3 Fasteners
2 Plate 4 Chemical anchors
To Next Page
Loading...