80 / 151 Issued: 16.06.2010 Version: MA KL 1500-3 T S 141215 V1 en
KL 1500-3; KL 1500-3 T; KL 1500-3 S
11.3.1 Installing the auxiliary device
Preconditions The linear unit has been prepared for exchanging the rollers.
The space available makes a partial removal of the carriage from the linear
unit possible, by moving the carriage to the side.
Auxiliary device available, article no. 00-122-061
The auxiliary device is not assembled.
Procedure 1. Screw the rail (>>> Fig. 11-7) to the strip using two M20x80-8.8 hexagon
bolts (5) together with lock washers and hexagon nuts. Tighten the hexa-
gon bolts with a torque of M
A
= 370 Nm.
2. Screw the carriage stop to the rail using an M10x25-8.8 Allen screw (6)
and lock washer. Tighten the Allen screw with a torque of M
A
= 45 Nm. The
stop must be attached so that the lower edge of the stop is flush with the
lower edge of the rail.
3. Remove the track cover on the fixed bearing side at the assembly position
of the auxiliary device. Remove the hexagon bolts and lock washers from
the cover and remove the cover.
4. Remove the bar with crash elements at the assembly position of the aux-
iliary device.
5. Remove the hexagon bolts and lock washers from the track cover and re-
move the cover, only if the auxiliary device is being installed on the floating
bearing side.
6. Mount the auxiliary device on the track and fasten it using two M20x80-8.8
hexagon bolts (11) and lock washers. Tighten the hexagon bolts with a
torque of M
A
= 370 Nm.
7. Exchange the rollers.
Fig. 11-6: Auxiliary device, installed
1 Stop for carriage 3 Track
2 Auxiliary device 4 Beam
To Next Page
Loading...