Kuka KL 1500-3 - Measures after Unintended Release; Handling and Storage; Exposure Limits and Personal Protective Equipment; Physical and Chemical Properties

125 / 151Issued: 16.06.2010 Version: MA KL 1500-3 T S 141215 V1 en
15. Appendix
15.1.1.6 Measures after unintended release
15.1.1.7 Handling and storage
15.1.1.8 Exposure limits and personal protective equipment
15.1.1.9 Physical and chemical properties
Personal safety
precautions:
Contact emergency personnel immediately. In case of spillage,
isolate the hazard area. Avoid contact with the hazardous sub-
stance and avoid inhaling vapors. Ensure adequate ventilation.
Where there is insufficient ventilation, wear suitable respiratory
equipment. Use suitable protective equipment.
Environmental precautions
and clean-up methods:
If no emergency personnel are available, contain spilled mate-
rial. Remove solid or absorbed material using a tool and place
in a suitable, labeled waste container. Prevent the product from
entering the drainage system, surface waters and soil. Notify
the competent authorities, if required.
Personal protection in the
event of a large spill:
Before handling this product, consult a specialist regarding pro-
tective equipment. Wear splash goggles, full suit, boots and
gloves.
Handling:
Prevent contact with skin or clothing. Spilled and leaked product
must be prevented from coming into contact with soil and sur-
face waters. Wash thoroughly after handling.
Storage:
Keep containers tightly sealed. Keep containers in a cool, well-
ventilated area.
Unsuitable:
Avoid prolonged exposure to increased temperatures.
Ingredient name: Threshold limit values (TLV) acc. to ACGIH (USA)
Base oil – unspecified
STEL: 10 mg/m
3
15 minute(s). Form: mineral oil mist
TWA: 5 mg/m
3
8 hour(s). Form: mineral oil mist
Further information can be obtained from the supplier.
Protective measures
Limitation and monitoring of
exposure in the workplace:
Provide exhaust ventilation or other engineering controls.
Hygiene measures:
Wash hands, forearms and face thoroughly after handling
chemical products.
Respiratory protection:
Sufficient ventilation is recommended in industry. If ventilation is
insufficient, respiratory protection is useful.
Hand protection:
Wear chemical-resistant gloves (recommended: nitrile gloves) if
prolonged or repeated contact is likely.
Eye protection:
Protective goggles with side shields to guard against splashing.
Skin and body:
Wear appropriate clothing to avoid prolonged skin contact.
Physical state:
Grease
Color:
Black
Odor:
Oily
Density:
<1000 kg/m
3
(<1 g/cm
3
) at 20 °C