67 / 151Issued: 16.06.2010 Version: MA KL 1500-3 T S 141215 V1 en
9. Maintenance
3. Remove enclosures if this is necessary in order to carry out the cleaning
work.
4. Clean the linear unit.
5. Completely remove all traces of cleaning agents from the linear unit.
6. Clean any areas of corrosion and reapply corrosion protection.
7. Remove cleaning agents and equipment from the workspace of the linear
unit.
8. Dispose of cleaning agents properly.
9. Install any safety equipment that has been removed and check that it is
functioning correctly.
10. Replace any damaged or illegible plates and covers.
11. Put back in place any enclosures that have been removed.
12. Put only fully functional linear units and systems back into operation.
To Next Page
Loading...