Kurzweil ExpressionMate - SP2 Test (Switch Pedal Only)

Messages, Troubleshooting, and Diagnostics
Diagnostics
101
If you plug in a switch pedal, pressing on the pedal should
produce the following display:
VPDL = SWITCH
CLOSED
When you take your foot off of the pedal, the display should
show this:
VPDL = SWITCH
OPENED
Note: Pedals made by Japanese manufacturers do the
opposite Ð youÕll see ÒCLOSEDÓ when your foot is off
of the pedal, and ÒOPENÓ when you push down on
the pedal.
SP2 Test (Switch Pedal Only)
Plug a switch pedal into the SP2 Jack. (If the pedal is already
plugged in, pull it out and plug it in again.) The display should
change to this:
SWITCH PEDAL
PLUG INSERTED
When you press down on the pedal, the display should show
this:
SWITCH PEDAL
CLOSED
When you lift your foot off of the pedal, the display should show
this:
SWITCH PEDAL
OPENED
Note: Pedals made by Japanese manufacturers do the
opposite Ð youÕll see ÒCLOSEDÓ when your foot is off
of the pedal, and ÒOPENÓ when you push down on
the pedal.
If you unplug the pedal, the display should show this:
SWITCH PEDAL
PLUG REMOVED
The display may change while you plug in or remove a pedal;
this is normal.