Editing and Creating Setups
Getting Around
23
Jump Selection
Jump selection moves you to the Þrst parameter for each
controller. For instance, if you are working on RBN parameters,
as shown here:
SU 1 15:40 Z1
RBN| Scale:100|
and you want to check the BRTH parameters, press both cursor
buttons (< and >) and youÕll get the Þrst parameter for BRTH:
SU 1 47:2 Z1
BRTH|Dest:Breath
Press both cursor buttons again to go to the control pedal
parameters and so forth to visit each controller. You can use a
similar method to change values: press the - and + buttons
simultaneously to change a value by large increments, such as 32
or 100.
While youÕre in the Controller Editor, you can also press and hold
the Controller button then press the Global button to jump to the
Fixed and Map controllers as well as note processing feature,
ribbon scale select, the note map, and MIDI channel parameters.
Intuitive Entry
Intuitive Entry gives you an even quicker way to enter values.
When youÕre in the Controller Editor, press and hold the
Controller button, then move the physical controller that you
want to adjust. The display will change to show the controller
youÕve selected and its initial parameter (ÒDestÓ or ÒTypeÓ). You
can choose other parameters for that controller by using the <
and > buttons.
Once youÕve selected a parameter, you can change its value by
holding the Learn button and moving the controller.
earn
L
xit
tore
S
E
To Next Page
Loading...
