Editing and Creating Setups
Continuous Control Pedal (CCPD) Parameters
40
Remember that you donÕt have to send just Breath (02) messages
with a breath controller. The ExpressionMate lets you send any of
the available Controllers in the Destination list.
PARAMETER RANGE OF VALUES DEFAULT
DESTINATION MIDI Destination List Breath
CURVE Curve List (See Text) None
CURVE AMOUNT 0–8 0
SCALE -300% to +300% +100%
OFFSET -127 to +127 0
RESOLUTION 7-Bit, 14-Bit 7-Bit
ENTRY VALUE None, 0–127, Current None
EXIT VALUE None, 0–127 None
Continuous Control Pedal (CCPD) Parameters
The rear-panel ÒSP1/CCÓ jack lets you connect a CC (Continuous
Control) pedal.
PARAMETER RANGE OF VALUES DEFAULT
DESTINATION MIDI Destination List None
CURVE Curve List (See Text) None
CURVE AMOUNT 0–8 0
SCALE -300% to +300% 100%
OFFSET -127 to +127 0
RESOLUTION 7-Bit, 14-Bit 7-Bit
ENTRY VALUE None, 0–127, Current None
EXIT VALUE None, 0–127 None
Switch Controller Parameters
Switch (physical) controllers have only two states: on and off. The
the ExpressionMateÔs switch controllers are:
• Panel Switches 1 and 2 (SW1 and SW2)
• Switch Pedals 1 and 2 (SP 1 and SP 2)
Switch Type (Type)
The parameters for switch controllers are slightly different from
those for continuous controllers. The Þrst parameter is Switch
Type (Type). The choices are Momentary in which a switchÕs
action lasts only as long as you are pressing it, and Toggle, in
which the switchÕs action lasts until you press it again. The
Momentary mode works best for functions like sustain or
To Next Page
Loading...
