Editing and Creating Setups
Note Processing Parameters
47
C# and so on. The rest of the maps work in the same fashion but
will skip two or three notes respectively. You can also use this to
add rhythmic holes in arpeggiations or play alternate sounds
from one key to the next. When set to Off, no notes will be sent.
Note that this will disable the ability for a Zone to send notes to
the arpeggiator.
ROM Scales
CCNoteScl allows you to choose from the following scales:
Chromatic (Chrom)
Major (Major)
Minor (Minor)
Melodic Minor (MelMin)
Harmonic Minor (HarMin)
Major Pentatonic (MjPent)
Minor Pentatonic (MnPent)
Expand Pentatonic 1(ExPnt1)
Expand Pentatonic 2(ExPnt2)
Blues (Blues)
Whole Tone (WholeT)
(W/HDim)
(H/WDim)
Harmonic (Harmon) see description that follows
Arpeggiator Latch Ascending (ArLchA)
see description that follows
Arpeggiator Latch Played (ArLchP) see description that follows
About The Harmonic Scale
The Harmonic Scale is a 14-note scale that spans 4 octaves and
contains those equal-tempered notes that most closely match the
Þrst 16 harmonics of the root pitch. After running past the 14
notes, the scale repeats at octave intervals. This scale sounds
great when setting a ribbon to play notes with -None- for the aux
destination (so it'll strum), holding the sustain pedal down, and
wailing away on the ribbon. Set another ribbon section to send to
CC note transpose (dest #43, NotOfs) so the scale can be
transposed.
About The Arpeggiator Latch Scales
These allow you to play unsorted, latched arpeggiator notes.
When Note Order is set to -None-, notes held in the arpeggiator
To Next Page
Loading...
