Editing and Creating Setups
Naming, Storing, and Exiting
57
Saving Your Work and Exiting
If you want to save the changes you made in the Controller
Editor, or exit the editor entirely, read the section below. If you
want to continue to the Arpeggiator Editor instead, read the next
section.
A quick shortcut for updating within an editor is to press the
Store button twice. Alternatively, you can press Store, then the
right cursor button (>) to save the changes youÕve made to a new
location.
Naming, Storing, and Exiting
Once youÕre done using the Controller Editor or Arpeggiator
Editor, you can name and store your changes as a User Setup.
You can also exit without saving changes.
The Store Button
If you want to name and store your work without leaving the
editor, press Store, and youÕll see this screen:
SU 3: Rename?
Big Strum |OK
Note: You can also name and save Setups from Play mode,
by pressing the Store button, to bring up name and
store dialogs. Press the Store button after reviewing
and/or changing each screen.
If you want to rename the Setup, use the < and > buttons to move
the cursor, and the data knob or - and + buttons to enter a name
of up to 12 characters. While naming, you can use the following
buttons for editing the name at the cursor position:
Controller swap upper/lower case
Arpeggiator insert a blank character
Global delete character
earn
L
xit
tore
S
E
To Next Page
Loading...
