ExpressionMate ROM Setups
115
Appendix B
ExpressionMate ROM Setups
The ExpressionMateÕs Setups are made for use with:
¥ a Controller that sends on MIDI channel 1 and
¥ a GM sound source.
Be sure to turn Local Control Off to avoid doubling notes if
youÕre set up in a MIDI loop (e.g., youÕre using a MIDI keyboard
as controller AND sound source). Also, make sure you're in
Multi-timbral mode on your sound source (usually the default
mode on modern synthesizers).
Some of the Factory Setups call up speciÞc GM programs by
sending Program Change messages. Since GM does not support
the bank controller, no Bank Select messages are sent.
If your sound source is not GM compatible, then you will
probably want to disable receiving Program Changes on
channels 1-3 on that device, while you experiment with the
Factory Setups. If your sound source is not capable of doing this,
or if you need it to respond to Program Changes for other
reasons, you can edit the Fix 1 Destination and change it to None,
or you can edit the Fix 1 Entry Value to any speciÞc Program
Change number that you want. If you want to approximate the
GM Program Changes sent by the Setups, a standard GM
program list will make a handy reference.
To Next Page
Loading...
