Editing and Creating Setups
MIDI Remap Controller (MAP) Parameters
44
PARAMETER RANGE OF VALUES DEFAULT
DESTINATION 0–40, 43–127 None
ENTRY VALUE None, 0–127 None
EXIT VALUE None, 0–127 None
MIDI Remap Controller (MAP) Parameters
The ExpressionMate includes three MIDI Remap Controllers.
These take incoming MIDI data, such as Modulation messages,
and turn the data into some other Controller message.
For instance, your MIDI keyboard might transmit only
Modulation (01) and Channel Pressure (Aftertouch) messages.
You might want to control the volume on a sound module, but
that device wonÕt change Mod Wheel or Channel Pressure
messages into Volume (07). In this case, you could set MAP1Õs
Source to ModWhl, and its Destination to Volume. Now the
ExpressionMate will change incoming Mod Wheel messages to
Volume messages. There are lots of other possibilities too.
The Source parameter lets you choose many of the Controllers
found in the Destination list (see page 48). The Special Functions
(33-63) and MIDI Controllers 120Ð127 arenÕt available as sources.
This is because most of the Special Functions are only found on
the ExpressionMate, and because remapping Controllers 120-127
(which send messages like ÒOmni OffÓ and ÒAll Notes OffÓ) isnÕt
useful. However, you can set Source to Pitch Bend (128) and
Channel Pressure (129), because you may want to remap these
Controllers.
One more thing: you can use a remap controller as a Þxed
controller by assigning None as the Source.
PARAMETER RANGE OF VALUES DEFAULT
DESTINATION 0–39, 43–127 None
SOURCE MIDI Destination List None
(with exceptions) plus
PBend and ChnPrs
CURVE Curve List (See Text) Linear
CURVE AMOUNT 0–8 0
OFFSET -127 to +127 0
SCALE -300 to +300 100
ENTRY VALUE None, 0–127 None
EXIT VALUE None, 0–127 None
To Next Page
Loading...
