Editing and Creating Setups
The Controller Editor
21
Chapter 3
Editing and Creating Setups
ItÕs possible that many of the Factory Setups will suit your needs
perfectly. However, you might want to customize some Setups, or
you may have a MIDI instrument that only responds to certain
messages. Therefore, you can edit every parameter of the
ExpressionMateÕs Setups by using two editors: The Controller
Editor and the Arpeggiator Editor. The Controller Editor section
starts below; the Arpeggiator Editor section starts in the
Arpeggiator chapter, on page 61.
The Controller Editor
While in Play mode, press the Controller button at the left of the
front panel. This brings you into the Controller Editor, where you
conÞgure the Ribbon, buttons, and other controllers for the
current Setup.
The Controller Editor parameters deÞne what each of a SetupÕs
Zones sends to the two MIDI Out ports, and to the Arpeggiator.
They also determine how the ExpressionMate responds to
devices connected to the MIDI In ports.
ontroller
C
12
Z
ones
E
dit
A
rpeggiator
13 23
To Next Page
Loading...
