ExpressionMate ROM Setups
Setup Descriptions
118
Setup Descriptions
1. ABS Bend - The ribbon sends pitch bend in absolute mode
with a spring set to return the pitch to the center.
2. REL Bend - MAP3 remaps modulation messages to arpeggi-
ated notes’ duration.
3. Big Strum - What you play on your controller ends up as a
scale on the ribbon. Play a chord then run your finger along the
ribbon to ascend up the notes you played.
4. ABS no Sprg - Map2 reverses pitchbend, up is now down.
Map3 sends arp note duration.
5. GM.Pb/Pan/Xp - Section 1 sends pitch bend. Section 2
sends MIDI pan, and Section 3 sends expression. Map3 sends
arp note duration.
6. GM.KeysRemap - The ExpressionMate is using its note
mapping features to play a different sound every three keys.
Each ribbon section controls volume for each sound.
7. GM.VelRemap - The velocity you play will determine what
sound or blend you hear. Ribbon section 1 controls pitch bend,
section 2 sends modulation, section 3 controls the Arpeggiator
tempo. SW1 changes the Shift Limit of the Arpeggiator.
8. Bass&Cym/Org - Section 1 sends modulation to the organ
and section 2 controls the organ volume. Section 3 controls the
Arp tempo (cymbal). The CCPD also controls the organ vol-
ume. SP1 sends modulation to the organ. Map 2 sends pitch
bend to the bass sound. Map3 controls modulation on the organ.
9. SheSellShell - Playing hard adds a low octave piano. Section
1 starts the waves and section 2 controls the waves’ speed. Press
SW1 to stop the waves. Press SW2 to start Zone 2 arpeggiating.
Section 3 controls the Arpeggiator’s note velocity for the low
piano.
To Next Page
Loading...
