Editing and Creating Setups
Switch Pedal (SP) Parameters
42
Off Value (Off V)
Off Value is the value of the Controller when you turn the switch
off. The default value is 0. Continuing the Òsoft switchÓ example
above, letÕs say you want to bring the Zone up to full volume
when you release the switch. Set the Off Destination to Volume
(07) and set the Off Value to 127.
Entry (Entr) and Exit States
Entry State can send an initial value for the switch when you
select the Setup. There are four choices: None (no change), Off
(the Off Value), On (the On Value), and Current. Current sends
the current state of the switch without changing it. It is different
than None, which speciÞes that nothing is to be sent on entry and
exit.
If a Panel SwitchÕs Entry State is ÒOn,Ó the switch will light as
soon as you select the Setup.
Exit State can send a value for the switch when you leave a
Setup. The choices On, Off, and None are available. This is very
useful for turning off Sustain when changing Setups, so you can
avoid ÒstuckÓ notes.
Switch Pedal (SP) Parameters
On the back of the instrument, there are two jacks for switch
pedals.
PARAMETER RANGE OF VALUES DEFAULT
SWITCH TYPE Momentary, Toggle Moment
ON/OFF DESTINATION MIDI Destination List SP1: Sustain
SP2: SostPd
ON VALUE 0–127 127
OFF VALUE 0–127 0
ENTRY VALUE None, On, Off, Current None
EXIT VALUE None, On, Off None
To Next Page
Loading...
