Kurzweil Forte SE - Page 226

Multi Edit Mode
MAIN Page
11-8
MIDI + LOCAL
When Destination is set to MIDI+LOCAL, MIDI data from the Zone is sent to a
Forte SE Program and to the MIDI Out ports.
USB
When Destination is set to USB, MIDI data from the Zone is sent only to the USB
ports.
USB + LOCAL
When Destination is set to USB+LOCAL, MIDI data from the Zone is sent to a
Forte SE Program and to the USB ports.
USB + MIDI
When Destination is set to USB+MIDI, MIDI data from the Zone is sent to the USB
& MIDI Out ports only. MIDI data is not sent to a Forte SE Program on this Zone.
USB + LOCAL + MIDI
When Destination is set to USB+LOCAL +MIDI, MIDI data from the Zone is sent
to the USB & MIDI Out ports, as well as the Forte SE Program on this Zone.
Channel
e Channel parameter determines the MIDI transmit and receive channel for the currently
selected Zone. You can set this parameter to any of the 16 MIDI channels (1-16).
You can assign dierent Zones to the same channel, but only one Program can be loaded in a
channel at a particular time. e Program loaded will be whichever program change message
is received last.
BankMode
e Bank Mode parameter determines the controller number with which MIDI Bank change
messages are transmitted. For MIDI Bank change messages, various manufacturers have
chosen dierent MIDI controller numbers. Most have chosen 0, 32, or both. In the case of
the Kurzweil K2600, it responds to controller 32, but is limited to 100 programs per bank.
You can set this parameter to any of the following:
None
MIDI Bank change messages are disabled.
Ctl0
MIDI Bank change messages are sent with controller number 0.
Ctl32
MIDI Bank change messages are sent with controller number 32.
Ctl0/32
MIDI Bank change messages are sent with both controller numbers 0 and 32.
K2600
MIDI Bank change messages are sent with controller number 32. (K2600 Program
numbers 0-99.)