Kurzweil Forte SE - Page 251

Multi Edit Mode
Audio Input (AUD-IN)
11-33
Mode
e Mode parameter determines whether the Multi will use its own Audio Input settings, or
whether it will use the Audio Input settings set in Global Mode.
By default, Mode is set to “Use Global Mode Eects”, which means the Multi will use the
Audio Input settings set on the Global Mode Audio Input page (for details see AUD-IN
(Audio Input Page) on page 12-23). If no FX Chain is selected in Global Mode, the Multi
Mode Audio Input page will display “(No aux)”.
Set Mode to “Multi Specic Eects” to enable Audio input eects for the current Multi.
When “Multi Specic Eects” is selected, the Chain, Control Ch and MODs parameters will
appear.
Chain
When the Audio Input Mode parameter is set to “Multi Specic Eects”, you can use the
Chain parameter to select an FX chain to apply to the rear panel 1/8” (3.5mm) input signal.
If you wish to edit a Chain, you can enter the Chain Editor by pressing the Edit button (see
Ch. 8 The Effects Chain Editor, on page 8-1 for details).
Note the “0/0 Units” in the middle of the top line of the page. e left-hand number is the
size of the Chain, and the right-hand number is the total number of units that the Multi is
attempting to use. A Multi can use a maximum of 32 FX units. If you exceed the maximum
number of DSP units, “(max 32)” will appear to remind you of the maximum.
When selecting an Audio Input Chain, the Chain may steal FX unit resources from other
channels in order to load. Because of this you may see some Channels on the FX page
become set to (Y) (higher numbered channels will be stolen rst).
Control Channel (Control Ch)
Use the Control Ch parameter to set the MIDI channel on which you wish to control Chain
Mods. See Channel on page 11-8 for details on Multi Zone MIDI Channels. See the MODs
section below for more details on Eect Chain Mods.
MODs
Eect Chain Mods are modulation controls which can be assigned to the Forte SE’s physical
controllers. Any Mods assigned within the selected Audio Input Chain can be controlled by
controllers assigned within the Multi.
e MODs eld displays any MIDI CC numbers which have been assigned to control FX
Chain Mods within the selected Audio Input Chain. To view which parameters these CC
numbers are assigned to, select the Chain eld and press the Edit button to enter the Chain
Editor, then go to the Chain Info page (see Ch. 8 The Effects Chain Editor, on page
8-1 for details).