Disk Mode
The Multiple Object Selector Page
13-35
Selection by Type/Range
This mode sets a speciÞc range of object types cross referenced with a speciÞc ID range.
It is possible to set the EndId before the StartId. If this is the case, no selection range will be
enabled.
Parameters Possible Values Function
Type Sample, Keymap,
Effect, Program, Set-
up, QABank, Vel-
Map, PrsMap,
IntTbl, Song, Table,
All Types
Sets the desired object type. The value All Types will
select all of the other possible types.
Bank 000's, 100's, 200's,
300's, 400's, 500's,
600's, 700's, 800's,
900's, All Banks
Sets the desired bank. Changing this parameter causes
the StartId and the EndId to be set to the limits of the cho-
sen bank (i.e. setting this to 300's will set the StartId to
300 and the EndId to 399). Setting this parameter to the
value All Banks will set the StartId to 0 and the EndId to
999.
The actual range used for selections when Toggle, Set,
or Clear is pressed is taken from the setting of the
StartId and EndId parameters. For example, if you set
the Bank to 200s and then change the StartID to 300 and
the EndID to 399, the 300s bank will be selected, not the
200s.
The Bank parameter is used as a quick way to set up the
Id range for an entire bank, or all banks.
StartID 0 - 999 Sets the specific starting ID of the selection range.
EndId 0 - 999 Sets the specific ending ID of the selection range.
To Next Page
Loading...