Connect the A.C. generator wire connector.
Clean the taper hole in the flywheel off any
burrs and dirt.
Install the woodruff key in the crankshaft
key way.
Install the flywheel onto the crankshaft with
the flywheel groove aligned with the
crankshaft woodruff key.
Hold the flywheel with the universal holder
and install the 10mm flywheel flange nut.
Torque: 3.5_ 4.0kg-m
Start the engine and check the ignition
timing. (
!
3-7)
Install other removed parts in the reserve
order of removal.
To Next Page
Loading...
