KYMCO MX'ER 50 - Lubrication System; Oil Pump Installation

4. LUBRICATION SYSTEM
4-4
MX’er 50
Oil Pump Driven Gear
Bolts
Nut
OIL PUMP INSTALLATION
Install the oil pump onto the crankcase.
Install the oil pump control cable plate.
Connect the oil inlet line and oil outlet line
properly.
Connect the oil pump control cable.
Bleed air from the oil pump.
• Lubricate the O-ring with grease or
engine oil before installation.
• Make sure that the oil pump is
inserted into the crankcase.
• Apply molybdenum disulfide or grease
to the pump pinion.
°Ø
Grease or Engine Oil
Control Cable
Oil Outlet Line
Oil Inlet Line
www.PlanDeGraissage.org