KYMCO MX'ER 50 - Spark Plug;Lubrication System

3. INSPECTION/ADJUSTMENT
3-5
MX’er 50
Gap, Wear, and Fouling Deposits
SPARK PLUG
Remove the spark plug
Check the spark plug for wear and fouling
deposits.
Clean any fouling deposits with a spark
plug
cleaner or a wire brush.
Specified Spark Plug: NGK: BR8HAS
Measure the spark plug gap.
Spark Plug Gap: 0.6_ 0.7mm
LUBRICATION SYSTEM
°mOil Filter Cltaning°n
Disconnect the oil tube at the oil pump side
and allow oil to drain into a clean container.
Remove the tube clip at the oil tank side and
disconnect the oil tube.
Remove the oil filter.
Cracks, Damage
Washer Deformation
When installing, first screw in the spark
plug by hand and then tighten it with a
spark plug wrench.
°Ø
Clip
Oil Filter
www.PlanDeGraissage.org