EasyManua.ls Logo

KYMCO MX'ER 50 - Lubrication System; Service Information; Troubleshooting

KYMCO MX'ER 50
213 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. LUBRICATION SYSTEM
4-2
MX’er 50
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• Use care when removing and installing the oil pump not to allow dust and dirt to enter the engine
and oil line.
• Do not attempt to disassemble the oil pump.
• Bleed air from the oil pump if there is air between the oil pump and oil line.
• If the oil is disconnected, refill the oil line with motor oil before connecting it.
SPECIFICATIONS
• Recommended Motor Oil: SAE20W20# 2-stroke Motor Oil
• Oil Capacity : 1.0 liter
Light comes on : 0.25 liter
TROUBLESHOOTING
Excessive white smoke or carbon deposits on spark plug
• Oil pump not properly synchronized (excessive oil)
• Poor quality oil
Engine overheating
• Oil pump not properly adjusted (insufficient oiling)
• Poor quality oil
Seized piston
• No oil in tank or clogged oil line
• Oil pump not properly adjusted (insufficient oiling)
• Air in oil line
• Faulty oil pump
Oil not flowing out of tank to engine
• Clogged oil tank cap breather hole
• Clogged oil filter
www.PlanDeGraissage.org

Table of Contents