HYDRAULIC BRAKE
BRAKE SYSTEM BLEEDING
Connect a transparent hose to the bleed
valve and fully apply the brake lever after
continuously pull it several times. Then,
loosen the bleed valve nut to bleed air from
the brake system. Repeat these steps until
the brake system is free of air.
BRAKE PAD/DISK
BRAKE PAD REPLACEMENT
Remove the two bolts attaching the brake
caliper holder.
Remove the brake caliper.
Push the brake caliper holder and then
remove brake pad.
Remove the other brake pad and pad
springs.
ASSEMBLY
Assemble the brake pads in the reverse
order of removal.
When bleeding air from the brake system,
the brake fluid level should be kept over
1/2 of the brake reservoir height.
To Next Page
