Kyocera Mita WP31C - Page 186

Installing the Memory Modules
A-5
4
44
4
Push out the clamps on both ends of the memory socket on the main controller board.
Figure A-5
5
55
5
Remove the memory module from its package. Aligning the cutouts of the memory
module with the matching keys of the socket, carefully plug the memory module into
the memory socket until it clicks in place.
Figure A-6
6
66
6
Push down the two socket clamps to secure the memory modules.
Figure A-7
7
77
7
After you finish installing the memory modules, reinstall the main controller board
and fasten it with screws.
Clamps
Cutouts
Clamps