Kyocera Mita WP31C - B.1 Parallel Interface

B.1 Parallel Interface
B-2
B.1 Parallel Interface
B.1.1 Communication Modes
The printer provides high-speed data transmission on a parallel interface. You can select the
parallel interface communication mode from the operation panel. To change communication
mode, see Chapter 3 Using the Operator Panel, section 3.5.1 Changing Parallel Interface
Mode on page 3-34.
Note
Use a parallel interface cable that complies with the IEEE 1284 standard.
You can choose from four communication modes:
Communication
Mode
Reception Transmission
Auto (default) High-speed/ECP Nibble/ECP
Nibble High-speed Nibble
High-speed High-speed —
Normal Normal —
Table B-1