Kyocera Mita WP31C - Changing Network Interface Parameters

3.5 Changing the Interface Parameters
3-37
3.5.3 Changing Network Interface Parameters
This printer supports TCP/IP, NetWare and EtherTalk protocols. In addition, you can install
the optional network interface card in the printer’s extension slot (OPT).
Using the operator panel, you can:
• Activate or deactivate TCP/IP, NetWare, and AppleTalk
• Activate or deactivate DHCP
• Enter IP address, subnet mask address, and default gateway address
• Determine whether to print a network status page when the printer is turned on
To confirm or change network card parameters, proceed as follows:
1
11
1
Press the MENU key.
2
22
2
Press the U or V key repeatedly until Interface > appears.
3
33
3
If the current interface is other than network, press the ENTER key. A blinking
question mark (?) appears.
If the optional network interface card is installed in the printer, Option will be
displayed. The setting procedure is basically the same even in this case.
4
44
4
Press the U or V key repeatedly until Network appears.
5
55
5
Press the ENTER key again.
Interface >
? Parallel
Interface >
? Network