Kyocera ECOSYS FS-1020MFP User Manual

2M4/2M5/2M6/2M7
1-4-24
Set paper in MF
tray and press OK.
Add paper Paper is not set in the Man-
ual Feed tray.
Load paper into the Manual
Feed tray and press [OK] key
to begin printing.
Toner is running
out.
Toner is running
out.
The toner is running out. Have a new toner container
ready.
Non-genuine Toner. Non-genuine toner
is installed
The installed toner container
is non-genuine.
When you want to use the
toner container currently
installed, press [Stop / Reset]
and [OK] key simultaneously
for 3 seconds or more.
Unknown toner
installed.PC
Error has occurred The installed toner con-
tainer's regional specification
does not match the
machine’s.
Install the specified toner con-
tainer.
USB connection
was cut.
Not connected. The machine cannot perform
this job due to a disconnec-
tion of the USB cable.
Press [OK] key and connect the
USB cable.
- Invalid driver The machine connected to
the current port is not sup-
ported by the printer driver.
Use a printer driver for this port
that matches the machine.
- Limited availability
for jobs
Unusable Time is in effect. To use the machine temporarily
during Unusable Time, enter
the unlock code.
Message Display Message Dis-
played in KYOC-
ERA client tool, and
the Status Monitor
Meaning Remedy

Kyocera ECOSYS FS-1020MFP Specifications

General

Print Technology	Laser
Print Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Paper Capacity	250 sheets
Connectivity	USB 2.0
Monthly Duty Cycle	20, 000 pages
Time to First Page	8.5 seconds
Duplex Print Mode	Manual
Scan Type	Flatbed
Output Capacity	100 sheets
Maximum Paper Size	A4
Functions	Print, Copy, Scan
Memory	32 MB
Print Speed	20 ppm
Copy Speed	20 pages per minute
Maximum Scan Area	8.5 x 14 inches
Fax Transmission Speed	Not supported