Section 6 OTHER CONVENIENT FUNCTIONS
6-49
With this mode, if you think you might want to make another set of
the same copies even after the initial copy job is finished, simply
turn the repeat copy mode ON and you can make the necessary
number of additional copies later. In order to maintain privacy, you
can make it necessary to enter a security code in order to use the
repeat copy mode so that, if the entered code doesn’t match the
registered security code, it will not be possible to use the repeat
copy mode.
NOTES
• Only one set of originals can be saved at one time for
repeat copying. Once you scan in new originals for
repeat copying, the data for the old originals will be
deleted.
• All data for repeat copying will be deleted in cases such
as when the power switch is turned OFF or the optional
scanner functions of the copier are use.
• The optional Memory Copy Board must be installed in
order to use this mode or function in standard copiers.
• You can prohibit repeat copying as well as make repeat
copying the default setting in the initial mode. (See
“Repeat copying ON/OFF” on page 7-92.)
Registering a copy job for repeat
copying
1
Set the originals to be copied.
2
Press the “Function” tab.
The content of the “Function” tab will be displayed.
3
Press the “T Down” key.
The content of the next portion of the “Function” tab will be
displayed.
4
Press the “Modify Copy” key.
The “Modify Copy” screen will be displayed.
Inch specifications
Metric specifications
5
Press the “On” key.
Inch specifications
Metric specifications
If you want to register a security code, go to the next step.
If you do NOT want to register a security code, go directly
to step 7.
Making more of the same copies after a copy job is finished
[Repeat copy mode]
!
"
#
$
%
&
'
()
*+
,-
*
*
./
'
'
0
'
!"
#$ %&
#
#
'
()
*
+
! "#$ % &
' (
)
(
**+,
*
-./
!" #$% &' ' (
) *
) + (
*
To Next Page
Loading...
