Section 7 COPIER MANAGEMENT
7-51
Auto sleep time
Perform the following procedure to set the amount of time that will
elapse after copying, or if no operation is performed, before the auto
sleep function turns the copier OFF.
1
Display the “Machine default” screen.
(See “Accessing the machine default settings” on
page 7-44.)
Inch specifications
Metric specifications
2
Select “Sleep mode changing time” under the “Default
menu” column on the left side of the touch panel and then
press the “Change #” key.
The “Sleep mode changing time” screen will be displayed.
Inch specifications
Metric specifications
3
Press the “+” key or the “-” key to change the displayed time
to the desired setting (between 15 minutes and
240 minutes).
Inch specifications
Metric specifications
NOTES
• It is recommended that you try to set a longer time
interval before auto sleep engages if you use the copier
frequently, and to a shorter time if there are long
intervals between use.
• If you want to quit the displayed setting without
changing it, press the “Back” key. The touch panel will
return to the screen in step 2.
4
Press the “Close” key.
The touch panel will return to the screen in step 2.
5
Press the “Close” key once again.
The touch panel will return to the “Default setting” screen.
6
Press the “End” key.
The touch panel will return to the contents of the “Basic”
tab.
!
!
!"# $
!%$
&
'(
)*
!"# $
!%$
&
'(
)*
!"#$
%#
!"#$
%#
To Next Page
Loading...
