Section 7 COPIER MANAGEMENT
7-96
Paper size and type
Perform the following procedure in order to use the multi-bypass
tray to feed copy paper.
1
With the content of the “Basic” tab displayed, press the
[Default Setting/Counter] key.
The “Default setting” screen will be displayed.
2
Press the “Bypass setting” key.
The “Bypass setting” screen will be displayed.
Inch specifications
Metric specifications
3
Press the key that corresponds to the size of paper to be
used, and then proceed to step 5. If you want to enter a
custom size, press the “Input size” key and then proceed to
the next step.
Inch specifications
Metric specifications
4
Press the “+” key or the “-” key to change each of the
displayed sizes (length and width) to the desired settings.
In metric specification copiers, the desired sizes can also be
entered directly by pressing the corresponding “#-Keys” key
and then using the keypad.
Inch specifications
Metric specifications
Multi-bypass tray paper settings
!
!
!!"
!
#
$
"
!
#
!!$
!!!%$ &
!
#
"
!
#
$
"
!
#
! $
!
!
"
# #
!
"
"
$$%
$
&
'
%
$
&
$$'
!"#$$
%
!"&%
!"#$ &
$$
$$
!
$'
$'
(
!
$'
) ! *
+ *
!"# !"#
$% &$' ()% )*&
&$' )&+
To Next Page
Loading...
