Section 7 COPIER MANAGEMENT
7-52
Auto low power time
Perform the following procedure to set the amount of time between
the point that copying ends and the energy-saving Low power mode
engages.
1
Display the “Machine default” screen.
(See “Accessing the machine default settings” on
page 7-44.)
Inch specifications
Metric specifications
2
Select “Low power mode chng. time” under the “Default
menu” column on the left side of the touch panel and then
press the “Change #” key.
The “Low power mode chng. time” screen will be displayed.
Inch specifications
Metric specifications
3
Press the “+” key or the “-” key to change the displayed time
to that desired (any available setting between 1 minute and
240 minutes).
Inch specifications
Metric specifications
NOTES
• The setting can be made to any 1-minute increment
between 1 minute and 45 minutes, 60 minutes,
90 minutes, 120 minutes, 180 minutes or 240 minutes.
• If you want to quit the displayed setting without
changing it, press the “Back” key. The touch panel will
return to the screen in step 2.
4
Press the “Close” key.
The touch panel will return to the screen in step 2.
5
Press the “Close” key once again.
The touch panel will return to the “Default setting” screen.
6
Press the “End” key.
The touch panel will return to the contents of the “Basic”
tab.
!
!
!"# $
!%$
&
'(
)*
!"# $
!%$
&
'(
)*
!"#$
%
!"#$
%
To Next Page
Loading...
