Section 6 OTHER CONVENIENT FUNCTIONS
6-60
Up to eight combinations of copy modes and other functions
displayed on the operation panel can be registered as a single
program using this function. You can also register a name for each
registered program.
Registering a program
1
Set the desired copy modes, etc., to be registered.
2
Press the “Program” tab.
The content of the “Program” tab will be displayed.
3
Press the “Register” key.
Inch specifications
Metric specifications
4
Press any key that is marked “No registration” and that
corresponds to the program key (1 - 8) under which you
want to register the settings.
The screen to register a name for that program will be
displayed.
Inch specifications
Metric specifications
5
Use the displayed keyboard to enter the desired name and
then press the “End” key.
Inch specifications
Metric specifications
NOTE
Refer to “Entering characters” on page 7-111 for
information on entering characters.
Memorizing frequently used settings [Program function]
!
"
#
$
%
&
'
(
!!)&
!
$
*
!
"
#
$
%
&
'
!"#$%&
'( ) *
+,-. / 0 1
2
3456
7 , 8
!"#$%
%
%
%
%
&' ( ) *
+,-. / 0 1
1
2
345 6
7 8 /
To Next Page
Loading...
