Section 4 BASIC OPERATION
4-5
9
Start copying
Press the [Start] key.
* Copying is possible once the lamp in the [Start] key is lit green
and “Ready to copy” is displayed.
Inch specifications
Metric specifications
10
At the end of copying
Finished copies will be ejected onto the top tray or the left tray, as
selected.
IMPORTANT!
• Up to 500 copies (standard copy paper: 60 g/m² –
90 g/m²) can be stored on the top tray, and up to 150
copies can be stored on the left tray. However, this limit
may differ depending upon the type and conditions of
the paper being used.
• If “The top tray exceeds capacity. Remove the paper.”
[“Too much paper in top tray. Remove paper.”] is
displayed, there are too many copies on the top tray.
Remove the copies from the top tray and then press the
[Start] key to resume copying.
• If ejected copies come out curled, or are otherwise not
stored cleanly, remove the paper from the
drawer[cassette] or the multi-bypass tray (whichever is
currently being used), turn the paper over, set it again
in that location and try to copy again.
! "
#$
%
"
!"
!
To Next Page
Loading...
