Section 7 COPIER MANAGEMENT
7-44
Accessing the machine default settings
Perform the following procedure when you want to access the
screens for each of the various machine default settings.
1
With the content of the “Basic” tab displayed, press the
[Default Setting/Counter] key.
The “Default setting” screen will be displayed.
2
Press the “Machine default” key on the left side of the touch
panel.
Inch specifications
Metric specifications
3
Use the keypad to enter the 4-digit management code.
The factory default setting is “3100”.
Inch specifications
Metric specifications
4
If the entered code matches the registered one, the
“Machine default” screen will be displayed.
Inch specifications
Metric specifications
NOTES
• It is possible for you to change the 4-digit management
code. (See “Changing the management code” on
page 7-60.)
• Refer to the desired procedure(s) explained under
“Making machine default settings” and perform the
corresponding setting(s).
!
!
! "
! #
$ !
! "
! #
$ !
To Next Page
Loading...
