Section 7 COPIER MANAGEMENT
7-48
Multi-bypass tray settings display ON/OFF
Perform the following procedure to have the “Bypass setting”
screen appear whenever the “Bypass” key is pressed in the “Basic”
tab.
1
Display the “Machine default” screen.
(See “Accessing the machine default settings” on
page 7-44.)
Inch specifications
Metric specifications
2
Select “Check bypass sizing” under the “Default menu”
column on the left side of the touch panel and then press
the “Change #” key.
The “Check bypass sizing” screen will be displayed.
Inch specifications
Metric specifications
3
Press the “On” key if you want to have the “Bypass setting”
screen appear.
Inch specifications
Metric specifications
NOTE
If you want to quit the displayed setting without changing
it, press the “Back” key. The touch panel will return to the
screen in step 2.
4
Press the “Close” key.
The touch panel will return to the screen in step 2.
5
Press the “Close” key once again.
The touch panel will return to the “Default setting” screen.
6
Press the “End” key.
The touch panel will return to the contents of the “Basic”
tab.
!
!
!"# $
!%$
&
'(
)*
!"# $
!%$
&
'(
)*
To Next Page
Loading...
